The Fenix WF26R is a tactical flashlight highly suitable for professional use, law enforcement, security, and emergency services. It boasts a maximum output of no less than 3,000 lumens and a beam range of 450 meters. You can easily cycle through the modes, which include an SOS function and a strobe mode.
Operating the Fenix WF26R
The WF26R features two buttons on the back of the lamp: the large round button turns the lamp on temporarily or continuously. The second button cycles through the modes. Pressing this button for half a second activates the strobe and SOS modes. When the lamp is off, holding down this button also activates the strobe.
Charging the Fenix WF26R
You charge the lamp using the included magnetic charging cable. This cable fits into the holder (also included), so you simply hang your lamp in it and it charges. However, you can also use the cable without the holder. It takes about 3 hours for the lamp to fully recharge.
The flashlight has a status indicator that shows you when it is time to recharge the lamp. With different light colors and flashing/non-flashing modes, you know exactly what the battery status is:
Green light constant on: 100% - 85%
Green light flashing: 85% - 50%
Red light constant on: 50% - 25%
Red light flashing: 25% - 1%
Light modes of the Fenix WF26R
Turbo: 3000 lumens, runtime of approx. 2 hours 41 min*
High: 1000 lumens, runtime of approx. 2 hours 47 min
Med: 350 lumens, runtime of approx. 8 hours 56 min
Eco: 30 lumens, runtime of approx. 44 hours
Strobe: 3000 lumens
SOS: 100 lumens
*The runtime of the highest light mode is calculated at the moment the lamp is switched on in the highest mode. After 2-3 minutes, the lamp automatically switches to the lower light setting via temperature control.
Fenix WF26R Accessories
The Fenix WF26R comes standard with one Fenix 21700 5000mAh Li-Ion battery, magnetic charging cable, charging cradle, wrist lanyard, and spare O-ring.
Intelligent protection
During prolonged use of turbo or high mode, the lamp generates a lot of heat. When the lamp reaches a temperature of 50°C or higher, it automatically reduces the lumen output slightly to lower the temperature. Once the temperature has dropped, it is possible to switch back to turbo mode.
